New & Revolutionary Transmitter Controlled Onboard Glow Igniter
Powered by your existing onboard battery
 
 

SwitchGlo needs no additional batteries and it is very easy to use. From your transmitter, just toggle your glow on and off, at start-up and in-flight. SwitchGlo uses new low power technologies, programmable integrated circuits, and custom software code to efficiently light your glow plug directly from the power it sees while plugged into your receiver.

• Transmitter controlled; toggle glow on/off at start-up and in-flight
• Powered by existing onboard battery from 4.8 to 8.0 volts
• Throttle programmable with mixable radios
• Audible alert indicates glow, and helpful locating downed aircraft
• 10 second automatic glow shut-off safeguard
• Extremely low power consumption; 2.2mah per 5 second pull
• Epoxy filled for protection and vibration immunity
• Solid case with flat sides; easy to velcro, or double-side tape it into place
• Works with all types of radios and nitro r/c crafts
• Easy installation, lightweight, durable, maintenance free

FULLY MIX PROGRAMMABLE! . . . . . . . USE YOUR GLOW WISELY!
    Eliminate "HOT STARTS" by disabling SwitchGlo switch on idle-up
    Flip SwitchGlo when bogging out before flight to avoid the "Walk of Shame"
    Flip SwitchGlo during autorotations to eliminate load-up & flooding
    Mix SwitchGlo to turn on at any throttle setting for landings

 How it works:  SwitchGlo plugs into an available receiver channel, then to your glow plug.  Simply assign a transmitter toggle switch to this channel, and toggle your glow on and off.  That's it!   The audible alert will sound while the glow plug is glowing. Plus, you can mix program SwitchGlo just as you can mix program any servo on your craft allowing you to utilize your glow in ways you never thought possible!  more

No spare RX channel? No problem!  see "GV-1" or "Y harness" installation options
Concerned about about battery drain? Read HeliRaptor's in-depth SwitchGlo review